Sewer Rehabilitation :  Forum
 
Goto Thread: PreviousNext
Goto: Forum ListMessage ListNew TopicSearchLog In
sewer network - metric pipe sizes
Posted by: ricardobrooks (IP Logged)
Date: August 10, 2018 06:34AM

Hello,

I have a metric drawing but under sewer network settings the units show up as imperial instead of metric. If I create a new sewer network the settings box inside the network command shows up as metric.
When designing a system for example and I use a 300mm dia. pipe the plan view is labeled right as a 300mm pipe but when I run a profile (10:1 vert) it gets labeled as 2500cm dia and plots at 25 meters tall on the profile. The manholes and inverts are plotted correctly. Any idea why it is doing this and how to fix it?

Any help will be apprecited.

I didn't find the right solution from the Internet.

References:
[update.carlsonsw.com]
IT asset management service video

Thank you.



Sorry, only registered users may post in this forum.